This 60 cm (2 ft) cable enables you to send MIDI messages from a USB-microDig with firmware v7.1 or higher directly to MIDI hardware. Configure the USB-microDig by connecting it to a computer with the USB cable that comes with the USB-microDig, then attach the USB-microMIDICable instead and send MIDI messages to MIDI gear. Power the USB-microDig from a USB battery, USB-microGlobalAdapter or USB port on a computer.

Operating instructions

1. Connect the USB-microDig to a computer with the standard micro-B-to-A USB cable.
2. Configure the sensor inputs with the EditorX software.
3. Enable MIDI Out in the Connect software.
4. Disconnect the USB-microDig from the computer.
5. Connect the USB-microDig to the USB-microMIDICable instead of the standard micro-B-to-A USB cable.
6. Connect the USB plug of the cable to a USB battery, USB-microGlobalAdapter or USB port on a computer. The red LED should be steady on.
7. Connect the MIDI part of the USB-microMIDICable to the MIDI input of the MIDI hardware device you want to send MIDI messages to.