Home About News New Customer My Account My Cart All products Download Support
Products Get Started
Demos Contact Us
Shop
Browse products
All products
My account
My quotes
My cart
Login
Currency:
Events
Click here for upcoming events ..


ioCube Touchdesigner plugin v1.x

For more sensor mapping and actuator control complexity, use your I-CubeX digitizer with the ioCube plugin for Touchdesigner on MacOS and Windows. The ioCube Touchdesigner node is a software module that facilitates the configuration of a digitizer and processes its sensor data so that it's ready for use in a Touchdesigner project, network or inside another node. It can also control the digitizer outputs and the connected actuators. Use Touchdesigner for free unless you are using it commercially.

Releases

04 Nov 2019: ioCube Touchdesigner plugin v1.10 for MacOS and Windows.

System requirements

  • Touchdesigner for MacOS or Windows.
  • A digitizer with firmware v6.0 or higher, including applicable drivers.

    • The USB-microDig requires a USB interface and drivers.
    • The Wi-microDig requires a Bluetooth interface, eg. the BluetoothAdapter, with drivers.
    • The WiDig requires a USB interface and drivers or a Bluetooth Low Energy (BLE) interface, with drivers.

Manuals and tutorials

  • Consult the support wiki and try the referenced example projects.
  • The ioCube was released at the Sensors & Touchdesigner workshop during the Touchdesigner Summit in Montreal on 19 August 2019. See this workshop guide for a summary.
  • The WiDig with firmware 8.11 or higher and USB-microDig with firmware 7.61 or higher are fully supported. Any older digitizer that communicates via a virtual serial port and is running its latest firmware version can still be used with ioCube but some features may not work correctly. The ioCube cannot connect with digitizers via MIDI or BLE-MIDI (yet).

Features

  • Sync ioCube node internal status data to the digitizer that's connected.
  • Configure analog as well as digital (I2C) sensors.
  • Output digital (I2C) sensor data in physical units of measurement.
  • Configure binary, pulse width modulated (PWM) as well as digital (I2C) actuators.
  • Full command set for configuring a digitizer in host mode.
  • Compatible with WiDig with firmware 8.11 or higher and USB-microDig with firmware 7.61 or higher.
  • Support for all other WiDigs, USB-microDigs and Wi-microDigs.
  • Auto configuration restore: automatic configuration re-load after a digitizer power cycle.
  • Digitizer version support: digitizer firmware and hardware are checked by ioCube.

Known issues

Please notify us if you encounter a bug or issue.

  • The ioCube cannot connect with digitizers via MIDI or BLE-MIDI (yet).
  • Older digitizers that communicate via a virtual serial port and are running their latest firmware version can be used with ioCube but some features may not work correctly. For instance USB-microDigs with firmware 7.4 only support analog sensors and a few digital sensors whilst on Wi-microDigs no outputs can be configured and even fewer digital sensors are supported.
  • When changing the sampling interval in the node's GUI in viewer-active mode, after editing the number, click outside the number widget and then again in the number widget to have the new sampling interval effectuated. Alternatively, use the node's parameters panel.
  • When changing the pulse interval or pulse width with the slider in the node's parameters panel, the value will not change as expected due to processing delays. Use the number field instead to set the values.

This page was updated on Tuesday 05 November 2019.
Comments by customers Write Review
There are currently no comments on this product.
Product Search




Advanced Search
Comments more
Write ReviewWrite a comment on this product!
Support
New Customers

Need help?

Resources

Downloads

User forums

Linkedin group LinkedIn group

Facebook page Facebook page
Instant SSL