about the BendMicro

Discussion of I-CubeX applications and use. Post here questions about your project, product suggestions, bugs, setup issues, ..

Moderator: Tech

Post Reply
shin
Posts: 3
Joined: Thu May 01, 2008 8:12 am
I-CubeX gear: Wi-microDig Firmware v6.1

about the BendMicro

Post by shin » Sun Jun 15, 2008 1:29 am

Will it be all right even if I cut the area of a yellow stripe of the BendMicro?
[attachment=0]bend.jpg[/attachment]
Attachments
bend.jpg
bend.jpg (18.76 KiB) Viewed 10572 times

Post Reply