Stacking two SlideWide v1.1 to make 2D touch sensor..
Posted: Fri Aug 08, 2008 3:12 am
Hi,
I am thinking of buying two SlideWide v1.1 sensors in order to stake them, making a 2D touch sensor.
Is there anything I need to be aware of?
Do I have to separate them using some material in between?
Can I put a thin plate on top, or must the finger touch directly on the sensor?
Cheers!
I am thinking of buying two SlideWide v1.1 sensors in order to stake them, making a 2D touch sensor.
Is there anything I need to be aware of?
Do I have to separate them using some material in between?
Can I put a thin plate on top, or must the finger touch directly on the sensor?
Cheers!