I have a problem with my Icube.
When trying to launch the IcubeX editor I get the following message:
"The digitizer firmware is -0.9. Please use an earlier version of the editor. This application requires firmware 4.1 or above. It will now exit".
I got this message after upgrading my OSX from 10.4.6 to 10.4.11. Before that everything worked ok.
The set up I use is
I-CubeX Digitizer MIDI interface RomI/O
PowerBook G4 with OSX 10.4.11
An advice will be much appreciated
Discussion of I-CubeX applications and use. Post here questions about your project, product suggestions, bugs, setup issues, ..
1 post • Page 1 of 1