Digitizer firmware

Discussion of I-CubeX applications and use. Post here questions about your project, product suggestions, bugs, setup issues, ..

Moderator: Tech

Post Reply
theodore
Posts: 1
Joined: Fri Oct 23, 2009 7:30 am
I-CubeX gear: ICubeX digitizer
sensors

Digitizer firmware

Post by theodore » Fri Oct 23, 2009 7:33 am

Hi

I have a problem with my Icube.

When trying to launch the IcubeX editor I get the following message:
"The digitizer firmware is -0.9. Please use an earlier version of the editor. This application requires firmware 4.1 or above. It will now exit".

I got this message after upgrading my OSX from 10.4.6 to 10.4.11. Before that everything worked ok.
The set up I use is
I-CubeX Digitizer MIDI interface RomI/O
PowerBook G4 with OSX 10.4.11

An advice will be much appreciated
best
Theodore

Post Reply