Difference between revisions of "Firmware-780 Commands"
(→General) |
|||
| Line 21: | Line 21: | ||
*[[Firmware-830 Command-051 |DUMP MUTE (51, 33h)]] | *[[Firmware-830 Command-051 |DUMP MUTE (51, 33h)]] | ||
| − | *[[Firmware- | + | *[[Firmware-780 Command-093 |MIDI OUT (93, 5Dh)]] |
| − | *[[Firmware- | + | *[[Firmware-780 Command-096 |DUMP MIDI OUT (96, 60h)]] |
| − | *[[Firmware- | + | *[[Firmware-780 Command-094 |MIDI CONFIG (94, 5Eh)]] |
| − | *[[Firmware- | + | *[[Firmware-780 Command-095 |DUMP MIDI CONFIG (95, 5Fh)]] |
| − | |||
| − | |||
| + | *[[Firmware-780 Command-111 |LOW POWER AND COM (111, 6Fh)]] | ||
==Standalone Mode== | ==Standalone Mode== | ||
Latest revision as of 02:10, 2 May 2023
Since most firmware 7.80 commands are the same as used in firmware 8.30, reference is made to firmware 8.30 information where applicable.
General
This section describes the messages and commands for resetting the USB-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining COM port status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode.
- CLEAR CONFIG (105, 69h)
- EDIT CONFIG (106, 6Ah)
- DUMP CONFIG (107, 6Bh)
- DUMP ALL CONFIG (108, 6Ch)
- DUMP CONFIG RANGE (109, 6Dh)
Dual Mode
This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
