Difference between revisions of "Firmware-780 Messages"
| Line 13: | Line 13: | ||
*[[Firmware-830_Message-071 |VERSION (71, 47h)]] | *[[Firmware-830_Message-071 |VERSION (71, 47h)]] | ||
*[[Firmware-830_Message-091 |MODE (91, 5Bh)]] | *[[Firmware-830_Message-091 |MODE (91, 5Bh)]] | ||
| − | *[[Firmware- | + | *[[Firmware-780_Message-096 |MIDI OUT (96, 60h)]] |
| − | *[[Firmware- | + | *[[Firmware-780_Message-095 |MIDI CONFIG (95, 60h)]] |
| − | *[[Firmware- | + | *[[Firmware-780_Message-111 |LOW POWER AND COM (111, 6Fh)]] |
Latest revision as of 02:13, 2 May 2023
Note that in the following listing the commands as echoed back by the USB-microDig (to allow multiple Max/MSP objects to work with a USB-microDig) are not included.
Since most firmware 7.80 commands are the same as used in firmware 8.30, reference is made to firmware 8.30 information where applicable.
General
- SOLO (33, 21h)
- RESET ACK (35, 23h)
- STATUS (37, 25h)
- MUTE (51, 33h)
- FIRMWARE (66, 42h)
- VERSION (71, 47h)
- MODE (91, 5Bh)
- MIDI OUT (96, 60h)
- MIDI CONFIG (95, 60h)
- LOW POWER AND COM (111, 6Fh)
Standalone Mode
