On 29 march a new build of
firmware v7.51 and
firmware v7.33 for the USB-microDig (with hardware v7.0 or greater) and
firmware v6.33 for the Wi-microDig (with hardware v6.0 or greater) was released. These builds fix a few bugs and add an easier way to upload new firmware, which method is used by a new version of
Connect v1.5.1. These new firmware versions address some compatibility issues with our other software and contain improved algorithms for digital sensors. If you're on a Mac, use the firmware uploader in Connect v1.5.1 (click on "Check firmware"). Or run
FirmwareX to upgrade your digitizer. Then configure it with
EditorX or
Link software. If you had uploaded one of these firmware versions before 19 March 2018, please re-upload this new firmware build to your USB-microDig or Wi-microDig. In Connect v1.5.1 you can check the build date of your firmware by clicking on the firmware version - after this firmware update the build date should show "2018-03-29".