Introducing .. the iCubino ! iCubinos are Arduino-compatible boards that can run our iCubino sketch. And since our Connect for MacOS software recognizes a device that's attached to the serial port if it speaks I-CubeX, so to say, iCubinos appear in the list of devices as an I-CubeX digitizer. Use our Shield to easily connect our sensors. All this is compatible with our existing software, so we're welcoming iCubino users to try out our software such as Link, SensePlay and I-CubeX plugins.

A new version 1.3.0 of Connect for MacOS to represent digitizers as virtual MIDI ports, was recently released. It sports some neat new features ! A mini configuration panel allows you to turn on/off sensor inputs, set the sampling interval, set the mode of operation, set muting and reset the digitizer. OSC output enables you to easily send sensor data to a slew of OSC-capable software programs and devices. Last but not least, Connect now allows you to convert any serial port into a virtual MIDI port.

Due to customer requests we're releasing new firmware v5.2 for the microDig as well, with some of the same great features as in firmware v7.2 for the USB-microDig, especially for standalone mode. It also works with EditorX. To upgrade it send us your microDig, using the instructions on our returns page. We will upgrade the microDig and send it back to you by regular mail, all for free ! Note that after this upgrade future upgrades won't require you to send it back to us again.

And today it's time to release new firmware v6.2 for the Wi-microDig, with some of the same great features as in firmware v7.2 for the USB-microDig, especially for standalone mode. It also works with EditorX. Start by running FirmwareX to upgrade your Wi-microDig.

Today we're releasing new firmware v7.2 for the USB-microDig, with many great features, especially for standalone mode. To make it possible to use these features we've built new EditorX software. Start by running FirmwareX to upgrade your USB-microDig - it's like putting it on steroids !