|
This 60 cm (2 ft) cable enables you to send MIDI messages from a USB-microDig with firmware v7.1 or higher directly to MIDI hardware. Configure the USB-microDig by connecting it to a computer with the USB cable that comes with the USB-microDig, then attach the USB-microMIDICable instead and send MIDI messages to MIDI gear. Power the USB-microDig from a USB battery, USB-microGlobalAdapter or USB port on a computer.
Operating instructions
- Connect the USB-microDig to a computer with the standard micro-B-to-A USB cable.
- Configure the sensor inputs with the EditorX software.
- Disable the USB-microDig serial interface in the Connect software.
- Run the MIDICable software (see below).
- Connect the USB-microDig to the MIDICable software by selecting the entry named "SLAB_USBtoUART".
- If not enabled, enable the USB-microDig for use with the USB-microMIDICable.
- Disconnect the USB-microDig from the computer.
- Connect the USB-microDig to the USB-microMIDICable instead of the standard micro-B-to-A USB cable.
- Connect the USB plug of the cable to a USB battery, USB-microGlobalAdapter or USB port on a computer. The red LED should be steady on.
- Connect the MIDI part of the USB-microMIDICable to the MIDI input of the MIDI hardware device you want to send MIDI messages to.
MIDICable releases
MacOS
05 Nov 2019: v1.22 (Mojave or higher, 64 bit)
21 Feb 2018: v1.21 (High Sierra or Mojave, 64 bit)
21 Feb 2018: v1.20 (Sierra or lower, 32 bit)
Windows
05 Nov 2019: v1.22 (Windows 10, 64 bit)
21 Feb 2018: v1.21 (64 bit)
21 Feb 2018: v1.20 (32 bit)
|