This is the kind of cable you want to use if your I-CubeX cables need a little slack. Handy for extending cables of sensors with two outputs.
For single output sensors use the ExtendCable-01, ExtendCable-05 or ExtendCable-10. For sensors with three outputs use ExtendCable3D-01. For digital (I2C) sensors or actuators use ExtendCableD-01.
||1.0 m (3.3
||10 g (0.40 oz)
||male 2x4 plug
with two rows, one with 3 pins and another with 1 pin, all spaced 2.54 mm (0.100 inch) and female 2x4 plug with two rows, one with 3 sockets and another with 1 socket, all spaced 2.54 mm (0.100 inch)
Use one of the two heatshrink sections to secure the connectors together. Slide the heatshrink section over the female connector of the extension cable. Plug the male connector of the sensor into the female connector of the extension cable. Apply heat evenly to the heatshrink using a heatgun (a hairdryer will also work) to shrink the heatshrink section so that it tightly covers the two connectors (also see the picture on this page). The second heatshrink section is a spare for future use.