 
|
Detects movement of humans and warm-blooded animals. Be there not or be I-CubeX-ed. Outputs a high value if no movement is detected within its field of view. If any movement is detected it outputs pulses that can be smoothed so as to get a signal that roughly corresponds with activity in the room.
Need lots of detail ? Try the MoveAround.
Application examples
- Use for detection of motion in rooms (doesn't detect presence of objects or humans, because only movement is detected).
Use two or more to determine the direction of a movement.
- Combine with a TapTiled floor, some MoveOn and/or ReachClose sensors and make sure every move of your visitor has an effect. The Flash + SeeLaser combo allows you to implement break-beams that could indicate borders or thresholds.
Technical specifications
| Product |
MoveOn sensor |
| Version |
1.4 (July 2012) |
| Sensing parameter |
motion of heat emitting object |
| Sensing method |
infrared (micrometer spectrum) differential |
| Active volume |
? ° cone |
| Range |
? m (? ft) within ? ° angle |
| Resolution |
1 bit (on or off) |
| Reset time |
less than 0.1 s (upon motion detection a low value is output for less than 0.1 seconds) |
| Calibration |
| Motion |
Voltage (use 5 V power supply) |
7-bit MIDI value (use 'no processing' editor preset) |
| no |
5.00 |
127 |
| yes |
0.00 |
0 |
| Power supply |
4.75 to 5.25 V DC, 1.6 mA |
| Sensor dimensions |
22 x 29 x 34 mm (mm (0.87 x 1.1 x 1.3 inch) |
| Weight |
20 g (0.71 oz), incl. cable |
| Cable |
1.0 m (39 inch), shielded, red wire = power, uninsulated wire = ground, black wire = sensor output, maximum extension ? m (? ft) |
| Connector |
male plug with 3 pins in a row spaced 2.54 mm (0.100 inch) |
| Software support |
- Our EditorX software allows you to configure the digitizer to process and map the sensor data of multiple sensors simultaneously.
- Our Link software allows you to receive the sensor data from the digitizer and use your computer to view, calibrate, record, process and map the sensor data of multiple sensors simultaneously.
- Our SensorX software allows you to receive the sensor data from the digitizer and use your computer to view, calibrate, record, process and map the data of a single sensor.
|
| Application notes |
- Make sure the sensor is plugged into the Digitizer with the red wire connected to power. Reversing the plug may cause damage to the sensor.
- The MoveOn sensor needs a few seconds before it is ready for stable operation.
- Best results are obtained if the sensor is placed up high, about 2 to 3 meter (7 to 10 feet) in the area it is being used in.
- The unit is not suited for environments with rapid temperature changes due to wind, heating devices or air conditioners, nor will the unit work well in environments with shocks and vibrations or environments with sunlight or other intense light aimed directly at the sensor.
|
|
LinkedIn group
Facebook page
Google+ page