An LED that provides intense visual feedback.
- It's pretty neat as an elevated-tech Christmas tree-top decoration.
- Use it to monitor the status of your gear from afar.
||1.0 (September 2020)|
||white LED indicator
||5 V DC, ? mA|
|| x x mm ( x x inch)|
|| g ( oz), incl. cable|
||1.0 m (39 inch), shielded, red wire = power, black wire = ground, white wire = n/c, maximum extension ? m (? ft)|
||male plug with 3 pins in a row spaced 2.54 mm (0.100 inch)|
- Our EditorX software allows you to configure the digitizer to control multiple actuators simultaneously with on/off as well as PWM signals.
- Our Link software allows you to control multiple actuators simultaneously with on/off signals.
- Can be controlled with an actuator output using on (5V) / off (0V) signals, as well as pulse width modulated (PWM) signals.
- Can be turned on and off directly with a Digitizer output (ie. the power supply pins of inputs 25 - 32).
- To turn it on and off with a Wi-microDig, it must run firmware v6.3 or higher. Move the pin of the plug that is connected to the red wire to the position of the pin connected to the white wire, which wire is not connected to anything and can be removed. Use a pointy object, eg. a tiny screw driver or sharp knife to take the pin out of the slot by slightly depressing the metal lever through the cutout for the pin attached to the white wire. Then, after having taken out the pin, push the lever out again a bit so that after placing the pin in the slot between the red and black wires, the lever blocks the pin from coming out of the slot. You can see these steps on page 4 and 5 of the HackPlugs v1.0 manual.