I-CubeX Forum

Please see http://infusionsystems.com/support/wiki ... e=Firmware.

Very enjoyable listen with great tips and tricks !

We've now released an openFrameworks addon, see http://icubex.com/ofxicubex, that makes it very easy to use I-CubeX with Raspberry Pi.

We tried interfacing the USB-microDig with a Raspberry Pi the other day and found that the driver for the USB-microDig is included in the operating system so it automatically creates a port /ttyUSB0 via which it's possible to communicate with the USB-microDig. We don't have any libraries or API for ...

We recently did some tests and found that the ReachClose can be placed right next to each other (length or width-wise) without the beam from one sensor interfering with the beam from another ReachClose.

New sizes are now available from our webshop. As mentioned on the product pages, still other sizes can be ordered. Please email sales with your request.

Please check http://icubex.com/matlab

Thanks so much for sharing your experiences !

The plug is compatible with any of the I-CubeX digitizers (see http://icubex.com/digitizers). To connect it to an Arduino board you could use our Shield (see http://icubex.com/shield) or you would have to take the wires out of the plug housing and connect them to the Arduino board separately .

Thanks for the nice feedback !

You can use the ReachClose preset, since the ReachClose has the same type of response, and modify it as you see fit. If you wanted to add this modified preset to your list of presets, you can edit the file presets.ini, which you can find in the directory where the Editor executable is.

On the sensor's webpage the active volume is listed as a cone of 5 degree width, ie. it gets wider the further you get away from the sensor. At 1 m the cone will be approx. 2 * 1 * tan (2.5) = 0.087, ie. 9 cm wide, so if you place the sensors about 10 cm apart and move your hand in front of the sens...

There is now a test version of Link that can configure all 32 inputs as well as 8 outputs of the Digitizer. Please go to http://icubex.com/link.

There is now a test version of Link that can configure all 32 inputs as well as 8 outputs of the Digitizer. Please go to http://icubex.com/link.

There's now a test version of Link that will enable you to control the actuators with MIDI note-on messages. Please go to http://icubex.com/link.