Hi
I have 8 reach ReachFar sensors. On the Processing preset inside I-CubeX editor there is no entry for "ReachFar" there are only Reach V2, Reach V3, ReachClose and ReachOn. I don't want to set up the editor with a wrong sensor. For example i don't know if Reach V2 or Reach V3 are previous versions of the Reach v4.0 which is very different from the ReachFar.
The I-CubeX Editor is version 3.4.
What setting do you recomend?
Reach Far Processing in I-CubeX Editor
Moderator: Tech
-
- Posts: 5
- Joined: Thu Aug 09, 2012 6:34 pm
- I-CubeX gear: ReachClose v2.2
Re: Reach Far Processing in I-CubeX Editor
You can use the ReachClose preset, since the ReachClose has the same type of response, and modify it as you see fit. If you wanted to add this modified preset to your list of presets, you can edit the file presets.ini, which you can find in the directory where the Editor executable is.
I-CubeX Technical Support
-
- Posts: 5
- Joined: Thu Aug 09, 2012 6:34 pm
- I-CubeX gear: ReachClose v2.2
Re: Reach Far Processing in I-CubeX Editor
Good! Thank you.