Comment on TouchMicro-10 v1.0

Discussion of I-CubeX applications and use. Post here questions about your project, product suggestions, bugs, setup issues, ..

Moderator: Tech

Post Reply
Noa Dolberg
Posts: 1
Joined: Wed Dec 31, 1969 7:00 pm

Comment on TouchMicro-10 v1.0

Post by Noa Dolberg »

apology for my ignorance, but to what exactly this 'male plug with 3 pins in a row spaced' is plugged to? arduino board? is there an additional connector to be used here? thanks
Posts: 77
Joined: Tue Dec 31, 2002 7:00 pm

Re: Comment on TouchMicro-10 v1.0

Post by Tech »

The plug is compatible with any of the I-CubeX digitizers (see To connect it to an Arduino board you could use our Shield (see or you would have to take the wires out of the plug housing and connect them to the Arduino board separately .
I-CubeX Technical Support
Post Reply