Comment on TouchMicro-10 v1.0

Discussion of I-CubeX applications and use. Post here questions about your project, product suggestions, bugs, setup issues, ..

Moderator: Tech

Post Reply
Noa Dolberg
Posts: 1
Joined: Wed Dec 31, 1969 7:00 pm

Comment on TouchMicro-10 v1.0

Post by Noa Dolberg »

apology for my ignorance, but to what exactly this 'male plug with 3 pins in a row spaced' is plugged to? arduino board? is there an additional connector to be used here? thanks
Tech
Posts: 77
Joined: Tue Dec 31, 2002 7:00 pm

Re: Comment on TouchMicro-10 v1.0

Post by Tech »

The plug is compatible with any of the I-CubeX digitizers (see http://icubex.com/digitizers). To connect it to an Arduino board you could use our Shield (see http://icubex.com/shield) or you would have to take the wires out of the plug housing and connect them to the Arduino board separately .
I-CubeX Technical Support
Post Reply