Page 1 of 1
Midi Pitch
Posted: Fri Dec 12, 2003 2:19 am
by Stephan Athanas
Hi,
Do you know if its possible to configure a sensor, that it gives out different Midi notes on, depending of the value of the sensor?
Thanks for help
Midi Pitch
Posted: Fri Dec 12, 2003 5:00 am
by Tech
Hi,
The Stand Alone mode of the I-CubeX digitizer allows only for sending one MIDI event per input. So you can get only one MIDI note-on for a sensor. A way around this would be to feed the signal output from a sensor to multiple inputs on the digitizer (using many HackCable). You could then program the digitizer to send different MIDI note-on from different threshold levels from all the inputs that are connected to this single sensor.
Regards.
--
Technical Support
Infusion Systems Ltd.