I-CubeX Forum

Posted: **Thu Jun 15, 2006 10:26 am**

Hi,

I am using the icubex system (number 41-40-10-xxxx) with a midi hubble and a computer. It worked well, but now somebody must have disconnected some sensores during the icubeX was active or something when I wasn't there and I can't get a connection again. I am getting error messages "Unable to properly connect to Digitizer" or "Failed to establish communication with digitizer"! The green LED is flashing all the time or green all of the time ...

What can I do?
Hoping for help - s

Posted: **Thu Jun 29, 2006 12:07 pm**

Hi.. I believe we spoke over e-mail. Works, right?

Posted: **Fri Feb 09, 2007 3:58 pm**

Did you get an answer for this? I think I might be having the same problem -- tech support at I-CubeX is looking into it but haven't been able to solve it yet

Posted: **Wed Feb 28, 2007 4:17 pm**

see post in subject 'minidig'

I-CubeX Forum

connection problems with I-CubeX "Unable to properly .

connection problems with I-CubeX "Unable to properly .