how raw is the data + device w.out I-CubeX software
Posted: Fri Aug 17, 2007 5:10 pm
firmware-61-wimicrodig.pdf says: “In host mode unprocessed, raw sensor
values are output only as system exclusive MIDI messages (ie. no stand-alone
mode type channel voice MIDI messages processed from sensor values are
output).”
Some very simple (dumb) questions, but I would be very glad for more light on these issues.
Is a system exclusive MIDI message surrounded by/in a MIDI format and not just simply the sampled value? If I have multiple sensors connected to the Wi-microDig how do I recognize which signal is from which sensor?
Can I use the Wi-microDig to send data/signals to a device that does not have I-CubeX software installed on it? Can I setup the Wi-microDig with a computer with the proper I-CubeX software and then in stand-alone mode send messages/data to a device which is not the same computer, but a different device with proper Bluetooth capabilities.
Thanks a plenty!
-W
values are output only as system exclusive MIDI messages (ie. no stand-alone
mode type channel voice MIDI messages processed from sensor values are
output).”
Some very simple (dumb) questions, but I would be very glad for more light on these issues.
Is a system exclusive MIDI message surrounded by/in a MIDI format and not just simply the sampled value? If I have multiple sensors connected to the Wi-microDig how do I recognize which signal is from which sensor?
Can I use the Wi-microDig to send data/signals to a device that does not have I-CubeX software installed on it? Can I setup the Wi-microDig with a computer with the proper I-CubeX software and then in stand-alone mode send messages/data to a device which is not the same computer, but a different device with proper Bluetooth capabilities.
Thanks a plenty!
-W