I-CubeX Forum

dear all

Can you use the I-CubeX with Pure Data aka Pd?

I hope so, but after much searching, I'm still looking for a definitive answer.
Not being able to use this site's search engine for the two-letter 'Pd' can't be helping ;-)


... & as a small token of gratitude, I hope you enjoy The Museum of Lost Interactions:
http://imd.dundee.ac.uk/moli
All the exhibits were built as fully working models
(using I-CubeX and MaxMSP, but with growing student numbers, we're looking towards Pd...)

best wishes
graham

Graham Pullin
Lecturer in Interactive Media Design
University of Dundee
g.pullin@dundee.ac.uk

You can use Pd with the built-in MIDI objects. You would need to put the I-CubeX in standalone mode, and then turn on the appropriate sensors with the editor. There still doesn't seem to be a working ., which would allow one to change configuration from within Pd, but that may show up eventually.