Wi-MicroDig connection problem
Posted: Mon Nov 19, 2007 1:39 pm
Hi,
we have been using the wi-microdig successfully with BioFlex sensors using both the C++ API and the MaxMSP development environment (on a PC)
Recently, however, we have not been able to connect to the Wi-Microboard using BlueMidi or any other interface. When the board is plugged into the 9V battery, the yellow LED light continually stays on (even after unplugging and re-plugging). I think the board is in stuck in some "on" state and cant properly connect. The wiminidig also shows a red LED when powered on.
Any ideas on next steps...Reinitialize the board?
thanks,
Anil
we have been using the wi-microdig successfully with BioFlex sensors using both the C++ API and the MaxMSP development environment (on a PC)
Recently, however, we have not been able to connect to the Wi-Microboard using BlueMidi or any other interface. When the board is plugged into the 9V battery, the yellow LED light continually stays on (even after unplugging and re-plugging). I think the board is in stuck in some "on" state and cant properly connect. The wiminidig also shows a red LED when powered on.
Any ideas on next steps...Reinitialize the board?
thanks,
Anil