Separating Flex Angle and Flex Radius

Discussion of I-CubeX applications and use. Post here questions about your project, product suggestions, bugs, setup issues, ..

Moderator: Tech

Post Reply
Posts: 1
Joined: Tue Nov 08, 2011 12:50 pm
I-CubeX gear: BendShort

Separating Flex Angle and Flex Radius

Post by roryokeeffe100 »


I am using a BendShort v2.0.
According to the infusion product page, the 'sensing parameter' is 'flex angle multiplied by flex radius'. In my project, it would be useful to separate these two measurements, ie have one measurement of flex angle, and one measurement of flex radius. Is this possible? Any thoughts and suggestions are welcome.

Post Reply