Difference between revisions of "Firmware-72 Format"
(Created page with "Infusion Systems I-CubeX USB-microDig MIDI implementation uses the following data format for all system exclusive messages: Byte Description 240 (F0h) System Exclusive Status...") |
|||
| Line 1: | Line 1: | ||
Infusion Systems I-CubeX USB-microDig MIDI implementation uses the following data format for all system exclusive messages: | Infusion Systems I-CubeX USB-microDig MIDI implementation uses the following data format for all system exclusive messages: | ||
| − | Byte Description | + | {| |
| − | 240 (F0h) System Exclusive Status | + | |Byte |
| − | 125 (7Dh) Manufacturer ID | + | |Description |
| − | {DEV} Device ID | + | |- |
| − | {CMD} Command or Message ID | + | |240 (F0h) |
| − | [BODY] Main Data | + | |System Exclusive Status |
| − | 247 (F7h) End of System Exclusive | + | |- |
| − | + | |125 (7Dh) | |
| + | |Manufacturer ID | ||
| + | |- | ||
| + | |{DEV} | ||
| + | |Device ID | ||
| + | |- | ||
| + | |{CMD} | ||
| + | |Command or Message ID | ||
| + | |- | ||
| + | |[BODY] | ||
| + | |Main Data | ||
| + | |- | ||
| + | |247 (F7h) | ||
| + | |End of System Exclusive | ||
| + | |} | ||
==Manufacturer ID== | ==Manufacturer ID== | ||
Revision as of 03:34, 3 November 2015
Infusion Systems I-CubeX USB-microDig MIDI implementation uses the following data format for all system exclusive messages:
| Byte | Description |
| 240 (F0h) | System Exclusive Status |
| 125 (7Dh) | Manufacturer ID |
| {DEV} | Device ID |
| {CMD} | Command or Message ID |
| [BODY] | Main Data |
| 247 (F7h) | End of System Exclusive |
Manufacturer ID
The manufacturer identifies the manufacturer of a MIDI device. Infusion Systems uses the number 125 (7Dh). Infusion Systems does not own the manufacturer ID 125 (7Dh). This ID is usually reserved for general educational and/or research equipment. Please ensure that you do not have any devices with manufacturer ID 125 (7Dh) in your MIDI chain.
Device ID
This ID identifies a specific USB-microDig in setups with multiple USB-microDigs. This setting should remain 0 for use of the USB-microDig in stand-alone mode. Host mode allows for device IDs other than 0.
Command and Message IDs and [Main Data]
The Command and Message IDs and [Main Data] form the protocol for communication with the USB-microDig. The protocol consists of commands that are sent to the USB-microDig and messages that are sent by the USB-microDig. The Command and Message ID description and [Main Data] formats are described starting on the next page.
