ICube Max Plugin-40 Commands

The iCube Max plugin responds to the following commands. If a command has aliases they are displayed following the command, in brackets and separated by commas. Commands that in turn send commands as System Exclusive MIDI messages to the digitizer refer to the firmware command in capitals.

System-wide commands

version (0 version)

Prints the iCube version and, if available, digitizer version.

reset (0 reset)

Initializes the iCube data structure and sends a RESET command to the digitizer.

init (0 init)

Initializes the iCube data structures

0 refresh

sync (0 sync)

Retrieves all the configuration information from the digitizer and stores it in the iCube data structure.

digid <value> (setdigid <value>, 0 digid <value>)

Sends a SET ID command to the digitizer to set the digitizer's System Exclusive ID to <value>.

id <value> (0 id <value>)

Sets the iCube to respond to and send System Exclusive messages with the System Exclusive ID equal to <value>.

host (0 host, 0 hostmode)

Sends a SET MODE command to the digitizer to set it to host mode.

standalone (0 standalone, 0 standalonemode)

Sends a SET MODE command to the digitizer to set it to standalone mode.

mode <value> (0 mode <value>)

Sends a SET MODE command to the digitizer so set to the mode specified by <value>.

interval (0 interval)

rate (0 rate)

mute (0 mute)

print (0 print)

verbose (0 verbose)

help (0 help)

thru (0 thru)

midiout (0 midiout)

power (0 power)

battery (0 battery)

clearconfig (0 clearconfig)

runningstatus (0 runningstatus)

activesensing (0 activesensing)

intervalmarking (0 intervalmarking)

Input-specific commands

connect (assign)

stream

on

off

sample

res

address

function (func)

method

analog, biobeat3d, hotspot2d, magnetic3d, moist3d, movealong, movearound, orient3d, orient4d, reachclosed, reachid, swipe3d

min

max

inmin

inmax

steps (step)

unit

offset

normal

noise

smooth

preset

raw