Difference between revisions of "Firmware-72 Function-123"
(Created page with "==MOVEALONG (123, 7Bh)== The MoveAlong function enables output of the MoveAlong sensor data in both host and stand-alone mode. In host mode the sensor data is output as an I2...") |
|||
| Line 6: | Line 6: | ||
{| | {| | ||
| + | !style="text-align:left;"|FP | ||
| + | !style="text-align:left;"|data output | ||
| + | |- | ||
|0..127: | |0..127: | ||
|Angular Velocity [-512..511]; a signed two’s complement 16-bit value, representing degrees/second, sent as two 8-bit bytes (MSB, LSB) | |Angular Velocity [-512..511]; a signed two’s complement 16-bit value, representing degrees/second, sent as two 8-bit bytes (MSB, LSB) | ||
Revision as of 16:30, 3 November 2015
MOVEALONG (123, 7Bh)
The MoveAlong function enables output of the MoveAlong sensor data in both host and stand-alone mode. In host mode the sensor data is output as an I2C DATA message. In stand-alone mode the sensor data is output according to the stand-alone mode settings of the input number that equals the I2C port number. There are no methods to select, ie. the FUNCTION command’s method/parameter FP is ignored:
MoveAlong v1.0
| FP | data output |
|---|---|
| 0..127: | Angular Velocity [-512..511]; a signed two’s complement 16-bit value, representing degrees/second, sent as two 8-bit bytes (MSB, LSB) |
Example:
In order to enable the MoveAlong function to get the angular velocity data from an MoveAlong sensor with I2C device address 0 (default MoveAlong I2C device address) connected to the 7th I2C port, the following message is sent:
- 240, 125, 0 {DEV}, 8 {FUNCTION}, 6 {yyy = 6}, 1 {device address}, 122 {MoveAlong function}, 0 {angular velocity method}, 247 (F0h, 7Dh, 00h, 08h, 06h, 01h, 7Bh, 00h, F7h)
In host mode raw sensor data will be output immediately in I2C DATA messages. In stand-alone mode a suitable configuration has to be set using the EDIT CONFIG command before any MIDI messages will be output. The sensor parameter’s raw values as output in a I2C DATA message are offset and scaled so as to fit in the channel voice MIDI value range of either 0-127 (eg. control-change message) or 0-16383 (pitch-bend message).
Other settings of the MoveAlong sensor can be effectuated by using I2C commands such as I2C WRITE and I2C READ.
