Difference between revisions of "Firmware-540 Intro"
(Copied from Firmware-640 Intro, revision 3905) |
|||
| Line 1: | Line 1: | ||
| − | The | + | The microDig is a thumb-sized hardware device that encodes analog voltage signals, such as generated by sensors, to music industry compliant MIDI messages with high resolution. |
| − | Use any of our many free software tools, such as the iCube and oCube Max/MSP plugins, to interface the | + | Use any of our many free software tools, such as the iCube and oCube Max/MSP plugins, to interface the microDig to your software application. |
| − | The firmware of the | + | The firmware of the microDig enables it to operate in both stand-alone mode (sensor data is processed before it is transmitted) as well as host mode (raw sensor data is transmitted). Stand-alone mode includes various sensor processing and mapping features such as gesture recognition that can be conveniently configured using our free editor. |
==Documentation== | ==Documentation== | ||
| − | This documentation describes the | + | This documentation describes the microDig firmware v5.40. The firmware version number can be obtained by sending DUMP VERSION and DUMP FIRMWARE VERSION commands to the microDig. If your microDig’s firmware is older than v5.40 you can most likely upgrade it to v5.40 using our software, freely available from [http://icubex.com I-CubeX.com]. |
| − | This specification is divided into general, stand-alone mode and dual mode sections addressing programming commands as understood by the | + | This specification is divided into general, stand-alone mode and dual mode sections addressing programming commands as understood by the microDig and transmitted messages as sent by the microDig. |
Latest revision as of 03:05, 17 December 2018
The microDig is a thumb-sized hardware device that encodes analog voltage signals, such as generated by sensors, to music industry compliant MIDI messages with high resolution.
Use any of our many free software tools, such as the iCube and oCube Max/MSP plugins, to interface the microDig to your software application.
The firmware of the microDig enables it to operate in both stand-alone mode (sensor data is processed before it is transmitted) as well as host mode (raw sensor data is transmitted). Stand-alone mode includes various sensor processing and mapping features such as gesture recognition that can be conveniently configured using our free editor.
Documentation
This documentation describes the microDig firmware v5.40. The firmware version number can be obtained by sending DUMP VERSION and DUMP FIRMWARE VERSION commands to the microDig. If your microDig’s firmware is older than v5.40 you can most likely upgrade it to v5.40 using our software, freely available from I-CubeX.com.
This specification is divided into general, stand-alone mode and dual mode sections addressing programming commands as understood by the microDig and transmitted messages as sent by the microDig.
