Difference between revisions of "Firmware-811 Command-108"
(Copied from Firmware-810 Command-108, revision 4327) |
|||
| Line 1: | Line 1: | ||
==DUMP ALL CONFIG (108, 6Ch)== | ==DUMP ALL CONFIG (108, 6Ch)== | ||
| − | The DUMP ALL CONFIG command is used to obtain all the current settings of the WiDig. Upon completion of the command the WiDig sends out multiple [[Firmware- | + | The DUMP ALL CONFIG command is used to obtain all the current settings of the WiDig. Upon completion of the command the WiDig sends out multiple [[Firmware-811_Message-107 |DUMP CONFIG messages]]. |
The WiDig will send out the configurations of all WiDig sensor inputs, including the virtual inputs, as well as all binary outputs when using the DUMP ALL CONFIG command with the following [BODY]: | The WiDig will send out the configurations of all WiDig sensor inputs, including the virtual inputs, as well as all binary outputs when using the DUMP ALL CONFIG command with the following [BODY]: | ||
Latest revision as of 16:15, 16 April 2019
DUMP ALL CONFIG (108, 6Ch)
The DUMP ALL CONFIG command is used to obtain all the current settings of the WiDig. Upon completion of the command the WiDig sends out multiple DUMP CONFIG messages.
The WiDig will send out the configurations of all WiDig sensor inputs, including the virtual inputs, as well as all binary outputs when using the DUMP ALL CONFIG command with the following [BODY]:
| 00000001: | 1; configuration number |
