Difference between revisions of "Firmware-811 Message-033"
(Copied from Firmware-810 Message-033, revision 4039) |
|||
| Line 1: | Line 1: | ||
==SOLO (33, 21h)== | ==SOLO (33, 21h)== | ||
| − | This message contains the WiDig SOLO status. See the [[Firmware- | + | This message contains the WiDig SOLO status. See the [[Firmware-811_Command-032 |SET SOLO command]] for more information on the SOLO feature. |
The [BODY] of the SOLO message is as follows: | The [BODY] of the SOLO message is as follows: | ||
Revision as of 16:20, 16 April 2019
SOLO (33, 21h)
This message contains the WiDig SOLO status. See the SET SOLO command for more information on the SOLO feature.
The [BODY] of the SOLO message is as follows:
| 0zyyyxxx: | xxx = [0..7]; sensor input number |
| yyy = [0..7]; virtual input number | |
| z = 0: disable solo | |
| z = 1: enable solo for the sensor input only |
