Difference between revisions of "IoCube TD Plugin"
| Line 1: | Line 1: | ||
| − | The ioCube plugin for [http://derivative.ca Touchdesigner] is a software module that facilitates the configuration of a digitizer and processes its sensor data so that it's ready to use in a | + | The ioCube plugin for [http://derivative.ca Touchdesigner] is a software module, or node, that facilitates the configuration of a digitizer and processes its sensor data so that it's ready to use in a Touchdesigner project, network or inside another node. It can also control the digitizer outputs and the connected actuators. The available features vary depending on the digitizer's [[Digitizers | hardware]] and [[Firmware | firmware]]. |
Revision as of 18:23, 4 August 2019
The ioCube plugin for Touchdesigner is a software module, or node, that facilitates the configuration of a digitizer and processes its sensor data so that it's ready to use in a Touchdesigner project, network or inside another node. It can also control the digitizer outputs and the connected actuators. The available features vary depending on the digitizer's hardware and firmware.
