Difference between revisions of "IoCube TD Plugin-10 Outputs"
| (One intermediate revision by the same user not shown) | |
(No difference)
| |
Latest revision as of 03:59, 16 August 2019
The Outputs parameter page allows you to configure each of the digitizer outputs as well as the pulse interval and width. For each input, select the actuator (where "Digital" groups all binary "on/off" actuators), select the actuator's method (if the actuator communicates via I2C) and then activate it, or (for binary actuators) switch the level or enable pulse output where the pulse width can be set.
Actuator methods are algorithms that execute a sequence of events. See the functions section of the firmware that is running on the connected digitizer.
