Difference between revisions of "Firmware-761 Commands"
| Line 8: | Line 8: | ||
*[[Firmware-811 Command-060 |OUTPUT INIT (60, 3Ch)]] | *[[Firmware-811 Command-060 |OUTPUT INIT (60, 3Ch)]] | ||
| + | *[[Firmware-811 Command-066 |DUMP FIRMWARE VERSION (66, 42h)]] | ||
*[[Firmware-811 Command-071 |DUMP VERSION (71, 47h)]] | *[[Firmware-811 Command-071 |DUMP VERSION (71, 47h)]] | ||
| − | |||
*[[Firmware-811 Command-090 |SET MODE (90, 5Ah)]] | *[[Firmware-811 Command-090 |SET MODE (90, 5Ah)]] | ||
Latest revision as of 15:43, 8 November 2019
Since many firmware 7.61 commands are the same as used in firmware 8.11/7.51, reference is made to firmware 8.11/7.51 information where applicable.
General
This section describes the messages and commands for resetting the USB-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining COM port status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode.
- CLEAR CONFIG (105, 69h)
- EDIT CONFIG (106, 6Ah)
- DUMP CONFIG (107, 6Bh)
- DUMP ALL CONFIG (108, 6Ch)
- DUMP CONFIG RANGE (109, 6Dh)
Dual Mode
This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
