Difference between revisions of "Firmware-810 Commands"
| (3 intermediate revisions by the same user not shown) | |||
| Line 7: | Line 7: | ||
*[[Firmware-810 Command-060 |OUTPUT INIT (60, 3Ch)]] | *[[Firmware-810 Command-060 |OUTPUT INIT (60, 3Ch)]] | ||
| − | *[[Firmware-810 Command-066 |DUMP FIRMWARE (66, 42h)]] | + | *[[Firmware-810 Command-066 |DUMP FIRMWARE VERSION (66, 42h)]] |
*[[Firmware-810 Command-071 |DUMP VERSION (71, 47h)]] | *[[Firmware-810 Command-071 |DUMP VERSION (71, 47h)]] | ||
| Line 15: | Line 15: | ||
*[[Firmware-810 Command-092 |SET ID (92, 5Ch)]] | *[[Firmware-810 Command-092 |SET ID (92, 5Ch)]] | ||
| − | *[[Firmware-810 Command-032 | | + | *[[Firmware-810 Command-032 |SET SOLO (32, 20h)]] |
| + | *[[Firmware-810 Command-033 |DUMP SOLO (33, 21h)]] | ||
*[[Firmware-810 Command-050 |SET MUTE (50, 32h)]] | *[[Firmware-810 Command-050 |SET MUTE (50, 32h)]] | ||
*[[Firmware-810 Command-051 |DUMP MUTE (51, 33h)]] | *[[Firmware-810 Command-051 |DUMP MUTE (51, 33h)]] | ||
| Line 37: | Line 38: | ||
*[[Firmware-810 Command-107 |DUMP CONFIG (107, 6Bh)]] | *[[Firmware-810 Command-107 |DUMP CONFIG (107, 6Bh)]] | ||
*[[Firmware-810 Command-108 |DUMP ALL CONFIG (108, 6Ch)]] | *[[Firmware-810 Command-108 |DUMP ALL CONFIG (108, 6Ch)]] | ||
| − | *[[Firmware-810 Command-109 |DUMP RANGE | + | *[[Firmware-810 Command-109 |DUMP CONFIG RANGE (109, 6Dh)]] |
Latest revision as of 15:45, 8 November 2019
General
This section describes the messages and commands for resetting the WiDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining COM port status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the WiDig specifically for stand-alone mode.
- CLEAR CONFIG (105, 69h)
- EDIT CONFIG (106, 6Ah)
- DUMP CONFIG (107, 6Bh)
- DUMP ALL CONFIG (108, 6Ch)
- DUMP CONFIG RANGE (109, 6Dh)
Dual Mode
This section describes the programming protocol commands sent to the WiDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
