Difference between revisions of "Firmware-811 Message-033"
(Copied from Firmware-810 Message-033, revision 4039) |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
==SOLO (33, 21h)== | ==SOLO (33, 21h)== | ||
| − | This message contains the WiDig SOLO status. See the [[Firmware- | + | This message contains the WiDig SOLO status. See the [[Firmware-811_Command-032 |SET SOLO command]] for more information on the SOLO feature. |
The [BODY] of the SOLO message is as follows: | The [BODY] of the SOLO message is as follows: | ||
| Line 13: | Line 13: | ||
|- | |- | ||
| | | | ||
| − | |z = 0: | + | |z = 0: solo disabled |
|- | |- | ||
| | | | ||
| − | |z = 1: | + | |z = 1: solo enabled for the sensor input only |
|} | |} | ||
Latest revision as of 17:27, 5 December 2019
SOLO (33, 21h)
This message contains the WiDig SOLO status. See the SET SOLO command for more information on the SOLO feature.
The [BODY] of the SOLO message is as follows:
| 0zyyyxxx: | xxx = [0..7]; sensor input number |
| yyy = [0..7]; virtual input number | |
| z = 0: solo disabled | |
| z = 1: solo enabled for the sensor input only |
