Difference between revisions of "Firmware-640 Commands"
(→General) |
|||
| (4 intermediate revisions by the same user not shown) | |||
| Line 16: | Line 16: | ||
*[[Firmware-810 Command-092 |SET ID (92, 5Ch)]] | *[[Firmware-810 Command-092 |SET ID (92, 5Ch)]] | ||
| − | *[[Firmware-810 Command-032 | | + | *[[Firmware-810 Command-032 |SET SOLO (32, 20h)]] |
| + | *[[Firmware-810 Command-033 |DUMP SOLO (33, 21h)]] | ||
*[[Firmware-810 Command-050 |SET MUTE (50, 32h)]] | *[[Firmware-810 Command-050 |SET MUTE (50, 32h)]] | ||
*[[Firmware-810 Command-051 |DUMP MUTE (51, 33h)]] | *[[Firmware-810 Command-051 |DUMP MUTE (51, 33h)]] | ||
| − | + | *[[Firmware-640 Command-111 |LOW POWER THRESHOLD (111, 6Fh)]] | |
| − | + | *[[Firmware-640 Command-114 |BATTERY VOLTAGE LEVEL (114, 72h)]] | |
| − | |||
| − | *[[Firmware-640 Command-111 |LOW POWER | ||
| − | *[[Firmware-640 Command-114 |BATTERY VOLTAGE LEVEL (114, | ||
| − | |||
==Standalone Mode== | ==Standalone Mode== | ||
| Line 37: | Line 34: | ||
*[[Firmware-810 Command-106 |EDIT CONFIG (106, 6Ah)]] | *[[Firmware-810 Command-106 |EDIT CONFIG (106, 6Ah)]] | ||
*[[Firmware-810 Command-107 |DUMP CONFIG (107, 6Bh)]] | *[[Firmware-810 Command-107 |DUMP CONFIG (107, 6Bh)]] | ||
| + | *[[Firmware-810 Command-108 |DUMP ALL CONFIG (108, 6Ch)]] | ||
| + | *[[Firmware-810 Command-109 |DUMP CONFIG RANGE (109, 6Dh)]] | ||
| + | |||
==Dual Mode== | ==Dual Mode== | ||
Latest revision as of 04:48, 20 July 2020
Since many firmware 6.40 commands are the same as used in firmware 8.10, reference is made to firmware 8.10 information where applicable.
General
This section describes the messages and commands for resetting the Wi-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining the Bluetooth port status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode.
- CLEAR CONFIG (105, 69h)
- EDIT CONFIG (106, 6Ah)
- DUMP CONFIG (107, 6Bh)
- DUMP ALL CONFIG (108, 6Ch)
- DUMP CONFIG RANGE (109, 6Dh)
Dual Mode
This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
