Difference between revisions of "Firmware-770 Commands"
(Created page with "Since many firmware 7.70 commands are the same as used in older firmware, reference is made to older firmware information where applicable. ==General== This section describe...") |
|||
| Line 1: | Line 1: | ||
| − | Since many firmware 7.70 commands are the same as used in older firmware, reference is made to | + | Since many firmware 7.70 commands are the same as used in older USB-microDig firmware or newer WiDig firmware, reference is made to this other firmware information where applicable. |
==General== | ==General== | ||
Revision as of 21:42, 24 February 2022
Since many firmware 7.70 commands are the same as used in older USB-microDig firmware or newer WiDig firmware, reference is made to this other firmware information where applicable.
General
This section describes the messages and commands for resetting the USB-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining COM port status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode.
- CLEAR CONFIG (105, 69h)
- EDIT CONFIG (106, 6Ah)
- DUMP CONFIG (107, 6Bh)
- DUMP ALL CONFIG (108, 6Ch)
- DUMP CONFIG RANGE (109, 6Dh)
Dual Mode
This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
