Difference between revisions of "Firmware-72 Command-050"
| Line 1: | Line 1: | ||
==SET MUTE (50, 32h)== | ==SET MUTE (50, 32h)== | ||
| − | The SET MUTE command stops the sampling of all sensor inputs. It can be used in both modes of operation (stand-alone, host). After completion of the SET MUTE command, the USB-microDig does not send out any MIDI messages representing sensor values. After a RESET, the USB-microDig is un-muted by default. The USB-microDig does not send out any messages upon completion of this command. | + | The SET MUTE command stops the sampling of all sensor inputs. It can be used in both modes of operation (stand-alone, host). After completion of the SET MUTE command, the USB-microDig does not send out any MIDI messages representing sensor values. After completion of a RESET command, a CLEAR CONFIG command or a SET MODE command the USB-microDig is un-muted by default. The USB-microDig does not send out any messages upon completion of this command. |
The [BODY] of the MUTE command: | The [BODY] of the MUTE command: | ||
Latest revision as of 04:29, 10 November 2015
SET MUTE (50, 32h)
The SET MUTE command stops the sampling of all sensor inputs. It can be used in both modes of operation (stand-alone, host). After completion of the SET MUTE command, the USB-microDig does not send out any MIDI messages representing sensor values. After completion of a RESET command, a CLEAR CONFIG command or a SET MODE command the USB-microDig is un-muted by default. The USB-microDig does not send out any messages upon completion of this command.
The [BODY] of the MUTE command:
| 0xxxxxxx: | xxxxxxx = 0; all sensor inputs un-muted |
| xxxxxxx = [1..127]; all sensor inputs muted |
Example:
- 240, 125, 0 {DEV}, 50 {SET MUTE}, 1, 247 (F0h, 7Dh, 00h, 32h, 01h, F7h)
