Difference between revisions of "Firmware-770 Command-111"
| Line 1: | Line 1: | ||
==LOW POWER AND COM (111, 6Fh)== | ==LOW POWER AND COM (111, 6Fh)== | ||
| − | This command sets the USB-microDig to dim the LEDs and report its serial port status. Upon completion of the command the USB-microDig sends out the [[Firmware-820_Message-111 | LOW POWER AND COM message]]. To get the LED and serial port status, send the command without body. | + | This command sets the USB-microDig to dim the LEDs and report its serial (COM) port status. Upon completion of the command the USB-microDig sends out the [[Firmware-820_Message-111 | LOW POWER AND COM message]]. To get the LED and serial (COM) port status, send the command without body. |
To set the LEDs, the [BODY] of the LOW POWER command should be as follows: | To set the LEDs, the [BODY] of the LOW POWER command should be as follows: | ||
Revision as of 00:55, 7 March 2022
LOW POWER AND COM (111, 6Fh)
This command sets the USB-microDig to dim the LEDs and report its serial (COM) port status. Upon completion of the command the USB-microDig sends out the LOW POWER AND COM message. To get the LED and serial (COM) port status, send the command without body.
To set the LEDs, the [BODY] of the LOW POWER command should be as follows:
| 01d00000: | d = 0; turn LEDs on |
| d = 1; dim LEDs |
