Difference between revisions of "EditorX-73 OSC"
| Line 17: | Line 17: | ||
The OSC port should be set to the port of the transmitting software or device. | The OSC port should be set to the port of the transmitting software or device. | ||
| − | [[File: | + | [[File:editorx-73_OSC-input_params.png]] |
| Line 23: | Line 23: | ||
The message text field should contain the string to match and optionally, if the string contains multiple numbers, a number to indicate which number in the string to use for actuator control. Messages that have been received are shown below the message text field. | The message text field should contain the string to match and optionally, if the string contains multiple numbers, a number to indicate which number in the string to use for actuator control. Messages that have been received are shown below the message text field. | ||
| − | [[File: | + | [[File:editorx-73_OSC-input_message.png]] |
Revision as of 18:23, 12 November 2016
The OSC Mapping window configures EditorX to output sensor input values as OSC messages as well as to receive OSC messages to control actuators.
Contents
Output Port
The OSC port should be set to the port of the receiving software or device.
Message
The Message Interval cannot be set lower than the Sampling Interval as set in the Options section. The message text field can contain multiple separate strings, in which case the same sensor data will be sent in multiple messages. Messages that have been sent are shown below the message text field.
Input Port
The OSC port should be set to the port of the transmitting software or device.
File:Editorx-73 OSC-input params.png
Message
The message text field should contain the string to match and optionally, if the string contains multiple numbers, a number to indicate which number in the string to use for actuator control. Messages that have been received are shown below the message text field.
