Difference between revisions of "Firmware-740 Messages"
| (One intermediate revision by the same user not shown) | |||
| Line 6: | Line 6: | ||
==General== | ==General== | ||
| + | *[[Firmware-810_Message-033 |SOLO (33, 21h)]] | ||
*[[Firmware-810_Message-035 |RESET ACK (35, 23h)]] | *[[Firmware-810_Message-035 |RESET ACK (35, 23h)]] | ||
*[[Firmware-810_Message-037 |STATUS (37, 25h)]] | *[[Firmware-810_Message-037 |STATUS (37, 25h)]] | ||
*[[Firmware-810_Message-051 |MUTE (51, 33h)]] | *[[Firmware-810_Message-051 |MUTE (51, 33h)]] | ||
| + | *[[Firmware-810_Message-066 |FIRMWARE VERSION (66, 42h)]] | ||
*[[Firmware-810_Message-071 |VERSION (71, 47h)]] | *[[Firmware-810_Message-071 |VERSION (71, 47h)]] | ||
| − | |||
*[[Firmware-810_Message-091 |MODE (91, 5Bh)]] | *[[Firmware-810_Message-091 |MODE (91, 5Bh)]] | ||
*[[Firmware-73_Message-096 |MIDI OUT (96, 60h)]] | *[[Firmware-73_Message-096 |MIDI OUT (96, 60h)]] | ||
Latest revision as of 15:44, 8 November 2019
Note that in the following listing the commands as echoed back by the USB-microDig (to allow multiple Max/MSP objects to work with a USB-microDig) are not included.
Since many firmware 7.40 commands are the same as used in firmware 8.10/7.3, reference is made to firmware 8.10/7.3 information where applicable.
General
- SOLO (33, 21h)
- RESET ACK (35, 23h)
- STATUS (37, 25h)
- MUTE (51, 33h)
- FIRMWARE VERSION (66, 42h)
- VERSION (71, 47h)
- MODE (91, 5Bh)
- MIDI OUT (96, 60h)
- MIDI STATUS (95, 60h)
- COM (111, 6Fh)
Standalone Mode
