Difference between revisions of "Firmware-72 Command-050"
(Created page with "==SET MUTE (50, 32h)== The SET MUTE command stops the sampling of all sensor inputs. It can be used in both modes of operation (stand-alone, host). After completion of the SE...") |
|||
| Line 13: | Line 13: | ||
|} | |} | ||
| − | Example: 240, 125, 0 {DEV}, 50 {SET MUTE}, 1, 247 (F0h, 7Dh, 00h, 32h, 01h, F7h) | + | Example: |
| + | |||
| + | :240, 125, 0 {DEV}, 50 {SET MUTE}, 1, 247 (F0h, 7Dh, 00h, 32h, 01h, F7h) | ||
Revision as of 15:40, 3 November 2015
SET MUTE (50, 32h)
The SET MUTE command stops the sampling of all sensor inputs. It can be used in both modes of operation (stand-alone, host). After completion of the SET MUTE command, the USB-microDig does not send out any MIDI messages representing sensor values. After a RESET, the USB-microDig is un-muted by default. The USB-microDig does not send out any messages upon completion of this command.
There [BODY] of the MUTE command:
| 0xxxxxxx: | xxxxxxx = 0; all sensor inputs un-muted |
| xxxxxxx = [1..127]; all sensor inputs muted |
Example:
- 240, 125, 0 {DEV}, 50 {SET MUTE}, 1, 247 (F0h, 7Dh, 00h, 32h, 01h, F7h)
