Difference between revisions of "Firmware-740 Messages"
| Line 1: | Line 1: | ||
Note that in the following listing the commands as echoed back by the USB-microDig (to allow multiple Max/MSP objects to work with a USB-microDig) are not included. | Note that in the following listing the commands as echoed back by the USB-microDig (to allow multiple Max/MSP objects to work with a USB-microDig) are not included. | ||
| + | |||
| + | Since many firmware 7.40 commands are the same as used in firmware 8.10/7.3, reference is made to firmware 8.10/7.3 information where applicable. | ||
Revision as of 20:51, 4 December 2018
Note that in the following listing the commands as echoed back by the USB-microDig (to allow multiple Max/MSP objects to work with a USB-microDig) are not included.
Since many firmware 7.40 commands are the same as used in firmware 8.10/7.3, reference is made to firmware 8.10/7.3 information where applicable.
General
- RESET ACK (35, 23h)
- STATUS (37, 25h)
- MUTE (51, 33h)
- VERSION (71, 47h)
- FIRMWARE VERSION (66, 42h)
- MODE (91, 5Bh)
- MIDI OUT (96, 60h)
- MIDI STATUS (95, 60h)
- COM (111, 6Fh)
Standalone Mode
