Difference between revisions of "Firmware-770 Commands"
| Line 1: | Line 1: | ||
| − | Since many firmware 7.70 commands are the same as used in | + | Since many firmware 7.70 commands are the same as used in other firmwares, reference is made to other firmware information where applicable. |
==General== | ==General== | ||
Revision as of 21:43, 24 February 2022
Since many firmware 7.70 commands are the same as used in other firmwares, reference is made to other firmware information where applicable.
General
This section describes the messages and commands for resetting the USB-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining COM port status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode.
- CLEAR CONFIG (105, 69h)
- EDIT CONFIG (106, 6Ah)
- DUMP CONFIG (107, 6Bh)
- DUMP ALL CONFIG (108, 6Ch)
- DUMP CONFIG RANGE (109, 6Dh)
Dual Mode
This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
