Difference between revisions of "Firmware-73 Command-107"
(Created page with "==DUMP CONFIG (107, 6Bh)== The DUMP CONFIG command is used to obtain the current settings of the USB-microDig. Upon completion of the command the USB-microDig sends out the [...") |
|||
| Line 9: | Line 9: | ||
|1; configuration number | |1; configuration number | ||
|- | |- | ||
| − | | | + | |00aaaaaa: |
| − | | | + | |aaaaaa = [0..63]; (virtual) sensor input number |
|} | |} | ||
Revision as of 03:56, 12 November 2016
DUMP CONFIG (107, 6Bh)
The DUMP CONFIG command is used to obtain the current settings of the USB-microDig. Upon completion of the command the USB-microDig sends out the CONFIG message.
The USB-microDig will send out the configuration of a USB-microDig sensor input when using the DUMP CONFIG command with the following [BODY]:
| 00000001: | 1; configuration number |
| 00aaaaaa: | aaaaaa = [0..63]; (virtual) sensor input number |
The Digitizer will send out the configuration of each USB-microDig binary output as well as the sample interval value when using the DUMP CONFIG command with a special value for the 2nd data byte in the [BODY]:
| 00000001: | 1; configuration number |
| 01111111: | 127; actuator outputs flag |
