Difference between revisions of "Firmware-73 Command-011"
| Line 9: | Line 9: | ||
{| | {| | ||
|00000yyy: | |00000yyy: | ||
| + | |x = 1; apply the command to all ports (yyy is ignored), ie. send 8 messages with the status for each port | ||
|- | |- | ||
| | | | ||
Revision as of 04:10, 20 November 2016
DUMP STREAM (11, 0Bh)
The DUMP STREAM command can be used to retrieve the sampling activation status of a port (configured for either an analog sensor or an I2C sensor) of a USB-microDig. The command can be used in both host and stand-alone modes of operation. Upon completion of the DUMP STREAM command the USB-microDig sends out the same message as the STREAM command.
The DUMP STREAM command has no [BODY].
The [BODY] of the STREAM command consists of a single 7-bit byte with the following format :
| 00000yyy: | x = 1; apply the command to all ports (yyy is ignored), ie. send 8 messages with the status for each port |
| yyy = [0..7]; port number, where the first port number = 0, and the last (8th) port number = 7 |
Example:
In order to retrieve the activation status of port 2 the following message is sent:
- 240, 125, 0 {DEV}, 11 {DUMP STREAM}, 2, 247 (F0h, 7Dh, 00h, 0Bh, 02h, F7h)
