Difference between revisions of "Firmware-73 Command-107"
(→DUMP CONFIG (107, 6Bh)) |
|||
| Line 9: | Line 9: | ||
|1; configuration number | |1; configuration number | ||
|- | |- | ||
| − | | | + | |00bbbaaa: |
| − | | | + | |aaa = [0..7]; sensor input number |
| + | |- | ||
| + | | | ||
| + | |bbb = [0..7]; virtual input number | ||
|} | |} | ||
Latest revision as of 00:31, 5 July 2017
DUMP CONFIG (107, 6Bh)
The DUMP CONFIG command is used to obtain the current settings of the USB-microDig. Upon completion of the command the USB-microDig sends out the CONFIG message.
The USB-microDig will send out the configuration of a USB-microDig sensor input when using the DUMP CONFIG command with the following [BODY]:
| 00000001: | 1; configuration number |
| 00bbbaaa: | aaa = [0..7]; sensor input number |
| bbb = [0..7]; virtual input number |
The Digitizer will send out the configuration of each USB-microDig binary output as well as the sample interval value when using the DUMP CONFIG command with a special value for the 2nd data byte in the [BODY]:
| 00000001: | 1; configuration number |
| 01111111: | 127; actuator outputs flag |
