Firmware-72 Command-105

CLEAR CONFIG (105, 69h)

The CLEAR CONFIG command sets all settings stored in non-volatile memory to default values and re-initializes all internal parameters to the initial values for a USB-microDig set to stand-alone mode (see RESET – note that the RESET is not executed). See the EDIT NAME, EDIT CONFIG commands for default values of settings stored in non-volatile memory. Upon completion of the command the USB-microDig sends the same command.

The [BODY] of the CLEAR CONFIG command:

00000001: 1; configuration number

Default values for each sensor input and all actuator outputs are re-instated:

MIDI out: 1; on MIDI running status 1; on System exclusive ID: 0 Mode of operation: 1; stand-alone Configuration name: “USB-uDig” Sensor sampling rate: 10 ms Sensor input MIDI mapping type: 3; control-change Sensor input impulse end notification: 0; off Sensor input impulse maximum set to constant: 0; off Sensor input cont. and/or impulse signal differentiation: 0; off Sensor input continuous signal averaging: 0; off Sensor input impulse signal processing: 0; off Sensor input continuous signal processing: 0; off Sensor input threshold: 0 Sensor input ceiling: 127 Sensor input noise gate: 0; off Sensor input time window: 0; off Sensor input function number: 0; off Sensor input function parameter 1: 0; Sensor input function device address / parameter 2: 0;

Sensor input to Actuator output mapping: 0; off Actuator output MIDI mapping type: 1; note-on Actuator output MIDI channel mapping: 0 Actuator output MIDI base mapping: 64 Actuator output response mode: 1; toggle mode Actuator output MIDI value threshold: 1 Actuator output status: 0; off Actuator output PWM status: 0; off Actuator output pulse interval: 20 ms Actuator output pulse width range: 1-2 ms