Difference between revisions of "Firmware-810 Command-107"
(Copied from Firmware-800 Command-107, revision 3120) |
|||
| Line 1: | Line 1: | ||
==DUMP CONFIG (107, 6Bh)== | ==DUMP CONFIG (107, 6Bh)== | ||
| − | The DUMP CONFIG command is used to obtain the current settings of the WiDig. Upon completion of the command the WiDig sends out the [[Firmware- | + | The DUMP CONFIG command is used to obtain the current settings of the WiDig. Upon completion of the command the WiDig sends out the [[Firmware-810_Message-106 |CONFIG message]]. |
The WiDig will send out the configuration of a WiDig sensor input when using the DUMP CONFIG command with the following [BODY]: | The WiDig will send out the configuration of a WiDig sensor input when using the DUMP CONFIG command with the following [BODY]: | ||
Revision as of 15:31, 8 December 2018
DUMP CONFIG (107, 6Bh)
The DUMP CONFIG command is used to obtain the current settings of the WiDig. Upon completion of the command the WiDig sends out the CONFIG message.
The WiDig will send out the configuration of a WiDig sensor input when using the DUMP CONFIG command with the following [BODY]:
| 00000001: | 1; configuration number |
| 00bbbaaa: | aaa = [0..7]; sensor input number |
| bbb = [0..7]; virtual input number |
The Digitizer will send out the configuration of each WiDig binary output as well as the sample interval value when using the DUMP CONFIG command with a special value for the 2nd data byte in the [BODY]:
| 00000001: | 1; configuration number |
| 01111111: | 127; actuator outputs flag |
