Difference between revisions of "Firmware-810 Message-033"

Revision as of 02:29, 11 December 2018

This message contains the WiDig SOLO status. See the SET SOLO command for more information on the SOLO feature.

The [BODY] of the SOLO message is as follows:

0yxxxxxx:	xxxxxx = [0..63]; sensor input
	y = 0: disable solo
	y = 1: enable solo for the sensor input only

@@ Line 10: / Line 10: @@
 |-
 |
-|y = [0..1]; 0: disable, 1: enable solo for the sensor input
+|y = 0: disable solo
+|-
+|
+|y = 1: enable solo for the sensor input only
 |}